Mirrors that keep themselves clear.

Yes. The face of a mirror is glass, the same silica surface GlassProtect is built for. We bond a clear nano layer to it so water beads up and sheets off and oily soap scum lifts far more easily, so the mirror keeps itself clearer on its own and needs far less hands-on cleaning. The one thing we can't fix is a mirror already going black at the edges, because that's the silver backing failing behind the glass, not the front face.

Largely, yes. GlassProtect makes water bead up and sheet off instead of clinging, so most of it simply runs away and the glass keeps itself clearer between cleans. It also lifts the oily soap scum a water-repellent-only surface leaves behind. Left to dwell on bare glass, hard water eventually etches it for good, and that etching is permanent. Because the coating resists that hard-water etching, the glass stays clear for the long run, and the occasional wipe it does ask for is far lighter work.

For years, not weeks. GlassProtect is still beading around 100 degrees after 3,000 scrub cycles in comparable cream-cleanser testing, roughly 3 times slower repellency loss than the leading brand. It fades slowly rather than failing all at once, and tops up without stripping. Every seal is registered under a JUMBOGUARD guarantee.

No. GlassProtect is a clear nano layer only tens of nanometres thick, optically clear and colourless, so the reflection is unchanged. All that changes is the surface energy, which is why water and scum stop gripping.

On glass, it strongly resists it, and this is the one surface where we make an etching claim. Permanent etching happens when hard water and cleaning residue are left to dwell on the glass. GlassProtect resists and delays that hard-water etching by keeping mineral water from dwelling long enough to attack, which is what protects the glass against the permanent etching you can't clean away. It doesn't make the glass immune, and it doesn't stop physical scratching or every chemical, it removes the dwelling that causes the damage.

Yes, and that's the honest promise. The hard part is done: water beads up and sheets off, and oily soap scum lifts far more easily, so the glass largely keeps itself clear and stays hands-off far longer between cleans. Constant hard, bore or reticulation water with no upkeep will still ask for the occasional wipe, on any glass on earth. The difference is that a coated mirror resists the hard-water etching that permanently clouds bare glass, so the effort you do put in keeps the glass clear for years instead of fighting a losing battle.

Yes, and you'll do it less often. A normal glass cleaner and a soft cloth is all it needs. Avoid harsh, high-alkaline products used neat and left to sit, and skip abrasive pads, since those are what shorten any coating's life. A gentle wipe keeps it working for years.